You've received the wireless fast charging platform for your Subaru Outback.

Before putting it to work, some assembly is required. Steps below describing the process.

• Platform with electronics installed;
• Two base legs/hooks: left and right;
• Back wall/bracket;
• Front panel;
• Size adjustment bumpers;
• 2 x 10 mm plastic rivets;
• 3ft USB-C cable (not presented on the picture;)

Align base legs and the main platworm as shown on the inage;

Slide each leg/hook into position;

Slide back wall/bracket into position;

There are "rails" that will hold pieces in the position;

Once back wall is set to position, it will hold the base legs/hooks and the main platform together;

• Pull the stem (yellow arrows) from each of included rivets;
• Insert rivet shells (red arrows) into the holes on the front panel as shown on the image;

• Flip the half assembled platform upside down;
• Slide the Front panel into position;

• Push preinstalled rivet bodies all the way in, so the Front panel will be reliably connected to the legs/hooks;
• Insert rivet stem into the rivet shell and push all the way in, locking the rivets;

• Select and install bumpers to accommodate the size of your phone;

If satisfied with the adjusted size, you may use a drop of the Superglue to permanently attach bumpers to the platform.

• Connect included 3ft USB cable to the charger (from the left side);
• Insert the entire assembly into the opening above the gloves compartment;
• Route the USB cable toward your selected power source (the cigarette lighter socket with USB adapter is recommended). Wire can be pushed between dashboard panels and would be practically invisible;
• Drop your phone in and charge it while you driving;