• M10 wrench or socket (for connecting O-ring to the ground);
• 2mm hex screwdriver;
• Pliers (maybe);
• Scissors or any kind of cutter (to cut zip ties);

• Open the box and verify all parts are intact and nothing is missing*;
• Make sure all required tools are ready;
• Get your wiring harness(s) prepped as described in the fuse tap adapter configuration guide**;
  

(*) - Attached image displays Type 1 brackets;

(**) - "Brooklyn Forest" edition brackets require two wiring harnesses;

• Route your wiring harness along the driver side pillar from the center of the grille toward main fuse box*;
  (no need to secure wires with zip ties or other means yet);
  
  (*) - example picture shows one side only;

• Thread the harness thru the grille from inside as shown on the pictures below;

• Push all connectors down between the scoop and the grille*;
  
  (*) - the location behind emblem is the most convenient as it has more room;

• Make sure all connectors are threaded thru the same opening in the grille on both sides;

• attach each LED connector to the wiring harness*;
  
  (*) - the sequence is not important as each LED is connected in parallel;

• Push bracket inside and behind the grille structure;

• Pull the wires out at the same time. Make sure connectors end up above the scoop;

• Hold the plate with your fingers;
• Make sure both knurled insert nuts are visible;

• Position outer frame with the screws inserted against the cell;
• Connect both pieces to each other with the screws*;
  
  (*) - Do not apply excessive force to tighten the screws. Finger tight is enough;

• When tightening the screws, make sure you do the outside screw first; The outer bracket will bend slightly inside the cell;
• Tighten inner screw. The bracket will bend a little more and take the shape of the cell;
• Repeat the same on the other side of the grille;
• Once both brackets are attached to the grille, route and secure both wiring harnesses along the driver side pillar. Use provided zip ties;

• Refer to the fuse tap setup guide;

• When attaching the fuse tap adapter and O-ring terminal, make sure BOTH harnesses are connected;

• Turn ON the ignition and make sure the LED are up*;
  
  (*) - do not start the car at this point;

• Once assured that the install is successful, close the hood and enjoy the new look of your vehicle;